Perhaps the most cost-effective method for improving general efficiency on gas and water infrastructure projects is to incorporate pre-fabricated bends and tees during the planning phase.

Pipe Systems Division uses specially adapted Gator butt fusion machines from Fusion Equipment for large volume pupped fittings, and Omicrom machines for the complex angles in mitred bends.

By stocking a huge range of different pipe types, diameters and SDR ratios, Pipe Systems Division is able to respond immediately to your specific needs.

The standard operating hours for the Pipe Systems Division's fabrication facility are from 10pm on Sunday to 10pm on Friday, although it is not unusual during times of peak demand for the plant to operate 24/7.

You can download a free copy of the Pipe Systems Division's Standard Fabrications catalogue in .PDF format by using the link at the bottom of this page.